Rostock Max V2 dual extrusion - top mount
jfettig
Location
Saint Cloud MN
| Filename | Downloads | Size | Uploaded | |
|---|---|---|---|---|
| top mount.png | 1162 | 121 kB | on 9/3/15 | Download |
| double mount2.stl | 904 | 723 kB | on 9/3/15 | Download |
| double mount2a.stl | 954 | 693 kB | on 9/3/15 | Download |
| knob.stl | 1002 | 1.3 MB | on 9/3/15 | Download |
| spool guide.stl | 961 | 333 kB | on 9/3/15 | Download |
| spool holders - 0-725 spool shaft-1.stl | 875 | 2.5 MB | on 9/3/15 | Download |
| spool holders - 1-25 spool shaft-1.stl | 969 | 2.6 MB | on 9/3/15 | Download |
| spool holders - 2-05 spool shaft-2.stl | 950 | 3 MB | on 9/3/15 | Download |
| spool holders - spool base-1.stl | 921 | 2.7 MB | on 9/3/15 | Download |
Description
Here is the dual cold end top mount setup I'm running, one spool on each side - use 6-32 screws and nuts to attach the bases, interchangeable spindles. based off another design I found(don't remember where).
1/8" NPT 4mm fittings for tubes, I run the tubes into the tops above the ezstruders as filament guides - same as bowdens but on the receiving end.
License
Attribution - Creative Commons
Comments
Sign in to add a comment.