This adjustable candle mount allows a candle to be placed directly inside the cut-out eyes of a Jack-O-Lantern. The two candle holding discs are sized for tea-light candles that are roughly 1.5 inches in diameter. In front of the candles is a mounting slot to allow for a variety of cornea silhouettes. Note: The cornea silhouettes are also designed to work without the candle mount by pressing the mounting stand into the pumpkin meat.

Print the "base" and the "upper" stl projects. The shafts of the "base" project fit into the slot of the shafts in the "upper" project. The shafts allow for length adjustment as needed to fit as follows: - The candle discs should be placed inside the pumpkin slightly below the eye cut-out by piercing the three prongs into the pumpkin meat. - The upper hinge should be pressed into the pumpkin meat that is exposed by the hole made in the top of the pumpkin (standard hole, mostly used to scoop out the pumpkin innards before carving). Tea-light candles can be placed in the candle discs, and lit either through the eye holes, or through the top hole - whichever is the safest (recommend long shaft lighter). Use the pumpkin_eye_mounts_fixed connected to one of the various cornea shapes in pumpkin_eye_shapes_fixed. These can either be inserted into the slot on the candle mounts, or they can be pressed into the pumpkin itself. Enjoy your bright-eyed Jack-O-Lantern!~

Attribution - Non-Commercial - Creative Commons

halloweencontest2015, halloween, contest, 2015