Put this spinning ghost on top of any pumpkin for an added Halloween flair! Please note that the reason that there are no pictures of it printed out is due to the fact that I don't own a 3D printer. Needs to have a candle below it to work.

When printing, you need to print the base piece (the circle with three bars on the inside) with a medium to high density and the rest of the model with a low density. When constructing, start by placing the fan piece inside of the base piece with the pole on the top sticking through the hole in the center of the base. Then, put the small connector piece on the end of the fan with some glue. At this point, the fan should be able to move freely, but should not be able to be separated from the base. Now put the ghost on top with more glue. Finally, put it on a pumpkin for some extra Halloween flair!

Attribution - Creative Commons

halloweencontest2015