straight bevel gear pinion and straight
adel
Description
straight bevel gear the pinion and the straight
Pinion
Module : 2, Number of teeth: 15, pressure angle: 20, face width: 14, Hub diameter: 25.3, mounting distance: 60, nominal shaft diameter: 15
Stright
Module : 2, Number of teeth: 45, pressure angle: 20, face width: 14, Hub diameter: 40, mounting distance: 40, nominal shaft diameter: 25
I used standard to design those gears
Ratio 1:3
Instructions
Printing:
I used PLA to print Maine but you can pick whatever you want !!
layer height used 0.2mm is more than enough for the straight but u can go smaller for the pinion (the small one) as 0.12mm.
Infill used 15% for the straight and with support, but you will notice in 1st layer above support a-holes that will disappear buy the second layer printed above it.
use Z distance on support to 0mm to get the layer in the same line.
speed used is the default one 60mm.
for pinion (the smaller ) go with layer height 0.12mm, and with 15 % or more, for infill,
don't forget to rotate them make the teeth to the top side.
License
Attribution - Creative Commons
Comments
Sign in to add a comment.