Case for Meegopad T2 PCB, 80x80x10 mm Fan, mini switch and wifi antenna This case solves the two major problems of the otherwise brilliant stick PCs: 1) Overheating causing thermal shutdown 2) poor Wifi performance. Results: -Core temperatures always below 40°C -WiFi throughput ca 4x better than original -No noticeable fan noise (34 dBA at 0.5m instead of 33dBA in my office)

Recommended print parameters for PLA on glass (wipe with acetone / ethanol before print): First Layer bed 75°C, extruder 215°C, 120% fill, 5mm brim Upper layers bed 75°C, extruder 195°C Parts (to be found on Aliexpress, approximate prices): Meegopad T2 (63 USD) 2.4 GHz PCB antenna 43x8mm (2USD) fan GDT 5V 80x80x10 mm (2.5 USD) resistor 10 Ohm 2W (0.5 USD) fan finger guard (0.8 USD) mini switch (0.5 USD) 4 screws M4x30 and M4 nuts , washers See images for assembly and soldering Tools: pliers, solder iron, screw driver

Attribution - Creative Commons

Meegopad, fan, case