Replacement Plexi Panels for Rostock Max v2
FilenameDownloadsSizeUploaded
Rear Panel v1.0_fixed.stl2020147 kBon 3/11/14 Download
side panels v1.1_fixed.stl857148 kBon 5/11/14 Download
Description
[v1.1: thinned the walls on the ends of the side panels a bit to try and clear the power switch. It slices this thin, but I can't go any thinner. If you need thinner, try a knife.] These panels will replace the plexiglass panels on the sides of the Rostock Max v2 (where the towers are) for the bottom section. They have vents on either side. The rear panel is a different size than the side panels, but the side panels for left and right are the same. Development branch at: https://bitbucket.org/redoverred/replacement-plexi-panels-for-rmv2
Instructions
Print 1 of the rear panel and 2 of the side panels for full matching set! You should obviously print them upright, not as they are in the STL. Add some brim to ensure they remain in place. You can print all 3 at once if you fit them right. These models have been netfabb'ed!
License
Attribution - Share Alike - Creative Commons
Comments
Sign in to add a comment.